HOLLOW SQUARE MORTICE CHISEL 3/8′ INDUSTRIAL 9.5mm

Industrial Quality
3/8"

Most mortisers are equipped to handle 1/4′, 3/8′, 1/2′ and 5/8” square chisels.
Converted to metric: 6,35mm, 9,5mm, 12,7mm and 15,9mm.

Some
are even capable of handling a 3/4′ chisel, but keep in mind that this is a
pretty healthy chunk to cut at one time and may require a lot of physical
exertion. Remember that even if you’re cutting a mortise that is 3/4′ wide, you
don’t need to cut the entire width in one pass. A few cuts down one side of the
mortise and then back up the other with a 1/2′ chisel will be just as effective
and not nearly as taxing on you as the operator.

Advantages:

• Faster than a chisel by hand
• Consistent in size
• Strong joints
• Reliable joints
• Looks good
• Large glue surfaces enhancing the strength
• Convenient